The Engine Ignition Analyzer OTI800 was created specically to perform quick and reliable diagnostics of non-starts, misfires, fouled up or damaged spark plugs and/or spark plug wires, by comparing digital read-outs of the spark plug voltage and spark burn time between cylinders on engines using Coil on Plug, Coil near Plug, conventional distributor/ignition coil, DIS (Distributor-less) or waste spark and magneto technologies.
OTI800 is a good tool for diagnosis of high coil failure in all vehicles.
How to use the OTI800 Engine Ignition Coil Diagnostic Tester?
1.Select the ignition system to be measured (spark plug wire or coil on plug), and the number of cycles.
2.Select the measurement to show in the main display (RPM, spark burn time and spark plug voltage) and secondary display (Minimum and Maximum of the main display or the complementary measurements).
3.Place the antenna’s capacitive pick-up on top of the Coil on Plug module, or over a spark plug or ignition coil wire, and then read the measurements on the LCD display.
Note: OTI800 tester requires a 9 Volt battery (type MN1604) for power supply. We will not configure batteries for the product. You need to purchase a suitable battery and install it yourself before you can use it.
OTI800 Spark Plug Ignition Tester Package Content
1* OTI800 Tester (not with battery)
1* User’s manual in English
1* Plastic case
