1. What is the minimum system requirement to run the software ?
All computers running Windows (any version) and having a USB port will do. The minimum screen resolution is 1024x600.
2. How to use the tool ?
- Have the ignition key in OFF position.
- Connect the OBD tool connector to the 4-pole RED DLC plug of the bike, and connect the USB plug to your Windows PC.
Warning: Never connect the OBD tool connector to a bike plug other than the RED plug.
- Start the OBD tool application.
- Select neutral, turn ignition On and have the engine stop switch in RUN position.
- Press the "Connect" button. The engine parameters must be shown on the screen.
- Start the engine if you wish to inspect parameters with the engine running.
3. Some parameters do not show any value, why ?
This means your vehicle does not have such kind of sensor, or that sensor data is not available through the OBD interface on your bike.
4. What is the maximum measuring time ?
The measuring time is unlimited (depends only on available disk space). The OBD Tool automatically starts the recording when you connect to the ECM.
5. What are the advantages of this product compared to the factory KDS tool ?
- Cost is fraction of the factory tool, affordable even for individuals and small repair shops.
- Connection to the ECM is easier and quicker, just press the Connect button and the OBD Tool does the rest.
- All sensor values are shown at the same time, on one screen.
- Can be used on a dyno, also when the rear wheel is spinning.
- The measurements are captured automatically and can be saved and played back from file.
- It is possible to monitor the sensors on Graph.
- The USB connection, compact size and auto setup make this product portable and extremely easy to use.
- The software runs on any version of Windows, you can run it on a hardware (laptop, netbook) of your choice.
- Rugged design, 100% weatherproof. Supplied in hard case.